Universal Vertical – Tool Holder This is our most popular tool holder. It will clamp from 1-1/8″ (28.6mm) to 2.0″ (50.8mm) for holding any tool vertically. It will fit on any ETA Forearm.UV-TH weighs 0.8 lb (0.36 Kg)
Universal Vertical – Tool Holder This is our most popular tool holder. It will clamp from 1-1/8″ (28.6mm) to 2.0″ (50.8mm) for holding any tool vertically. It will fit on any ETA Forearm.UV-TH weighs 0.8 lb (0.36 Kg)
Thin Universal Vertical – Tool Holder For fastening Vertically with any inline tool. Certain tools do not have enough area (1 inch) of the same diameter to use the UV-TH holder. The TUV-TH is identical to UV-TH except it is only 0.540 ” (13.7mm) thick for tools with less clamping area.TUV-TH weighs 0.5 lb (0.23… Read more »
SWivel –Tool Holder Use this holder for inline air tools only. For fastening on angles off of vertical. Tool is mounted by 1/4 npt tool connection. SW-TH is included on model PA506-SW. SW-TH weighs 1.1 lbs (0.5 Kg)
Right Angle Vertical – Tool Holder This holder is for Right Angle Wrenches driving fasteners downward or upward. Spring loaded Thumb Latch allows 12 different handle positions instantly adjustable. It will clamp from 1-1/8″ (28.6mm) to 2.0″ (50.8mm) diameter tool bodies. RAV-TH weighs 1.6 lbs (0.73 Kg)
Pistol Spin – Tool Holder This holder will clamp from 1-1/8″ (28.6mm) to 2.0″ (50.8mm) diameter Pistol or Inline tool bodies and hold them on the horizontal plane while allowing them to spin sideways for axial alignment.
Pistol Tilt – Tool Holder This holder will clamp from 1-1/8″ (28.6mm) to 2.0″ (50.8mm) diameter Pistol or Inline tool bodies and hold them in a basic horizontal attitude while allowing them to tilt 20+ degrees below and above the horizontal plane and also spin sideways for axial alignment without any torque reaction. The tilt… Read more »
Right Angle Horizontal – Tool Holder For driving fasteners sideways using a right angle tool. RAH-TH has 12 handle angle positions that can be changed instantly. Clamp any air tool body diameter from 1-1/8″ to 2.0″ (28.6 to 50.8mm). RAH-TH weighs 2.3 lbs (1.05 Kg)
Right Angle Horizontal & Vertical – Tool Holder If your application requires you to drive vertical fasteners and horizontal fasteners in the same work zone using the same Right Angle tool, then the RAHV-TH on an 815 or 1015 arm can be an excellent ergonomic improvement. We designed this RAHV holder to be versatile and… Read more »
Inline or Pistol Horizontal & Vertical – Tool Holder If your application requires you to drive vertical fasteners and horizontal fasteners in the same work zone using the same Inline or Pistol tool, then the IPHV-TH on an 815 or 1015 arm can be an excellent ergonomic improvement. We designed this IPHV holder to be… Read more »
Flip & Rotate – Tool Holder FR-TH is for Inline or Pistol tools fastening in any direction, Vertical, Horizontal, side to side, up, down and any angle in between, without torque reaction or tool weight. With the FR-TH on an ETA torque arm the tool will stay suspended at any height you leave it, please… Read more »