Universal Vertical – Tool Holder This is our most popular tool holder. It will clamp from 1-1/8″ (28.6mm) to 2.0″ (50.8mm) for holding any tool vertically. It will fit on any ETA Forearm.UV-TH weighs 0.8 lb (0.36 Kg)
Universal Vertical – Tool Holder This is our most popular tool holder. It will clamp from 1-1/8″ (28.6mm) to 2.0″ (50.8mm) for holding any tool vertically. It will fit on any ETA Forearm.UV-TH weighs 0.8 lb (0.36 Kg)
Thin Universal Vertical – Tool Holder For fastening Vertically with any inline tool. Certain tools do not have enough area (1 inch) of the same diameter to use the UV-TH holder. The TUV-TH is identical to UV-TH except it is only 0.540 ” (13.7mm) thick for tools with less clamping area.TUV-TH weighs 0.5 lb (0.23… Read more »
SWivel –Tool Holder Use this holder for inline air tools only. For fastening on angles off of vertical. Tool is mounted by 1/4 npt tool connection. SW-TH is included on model PA506-SW. SW-TH weighs 1.1 lbs (0.5 Kg)
Extended Reach Universal Vertical – Tool Holder Similar to UV-TH with an additional 3″ extension. It will clamp from 1-1/8″ (28.6mm) to 2.0″ (50.8mm) for holding any tool vertically. It will fit on any ETA Forearm.EXUV-TH weighs 1.2 lb (0.55 Kg)
Simple Right Angle – Tool Holder The SRA holds your right angle tool handle upward and allows it to swing freely 280 degrees foreasy axial alignment with your fasteners. The SRA will clamp any tool body diameter from1” to 2.0” (28.6 to 50.8mm).
Right Angle Vertical – Tool Holder This holder is for Right Angle Wrenches driving fasteners downward or upward. Spring loaded Thumb Latch allows 12 different handle positions instantly adjustable. It will clamp from 1-1/8″ (28.6mm) to 2.0″ (50.8mm) diameter tool bodies. RAV-TH weighs 1.6 lbs (0.73 Kg)
Pistol Spin – Tool Holder This holder will clamp from 1-1/8″ (28.6mm) to 2.0″ (50.8mm) diameter Pistol or Inline tool bodies and hold them on the horizontal plane while allowing them to spin sideways for axial alignment with fastener.
Pistol Tilt – Tool Holder This holder will clamp from 1-1/8″ (28.6mm) to 2.0″ (50.8mm) diameter Pistol or Inline tool bodies and hold them in a basic horizontal attitude while allowing them to tilt 20+ degrees below and above the horizontal plane and also spin sideways for axial alignment with fastener, without any torque reaction…. Read more »
Right Angle Horizontal – Tool Holder For driving fasteners sideways using a right angle tool. RAH-TH has 12 handle angle positions that can be changed instantly. Clamp any air tool body diameter from 1-1/8″ to 2.0″ (28.6 to 50.8mm). RAH-TH weighs 2.3 lbs (1.05 Kg)
Right Angle Horizontal & Vertical – Tool Holder If your application requires you to drive vertical fasteners and horizontal fasteners in the same work zone using the same Right Angle tool, then the RAHV-TH on an 815 or 1015 arm can be an excellent ergonomic improvement. We designed this RAHV holder to be versatile and… Read more »